TORK CRAFT Wire Wheel Brush 150 X 25mm Bench Grinder Blister

Features

• Engraved graduations of 1mm on ruler.
• Metric measurements.
• Square and protractor head comes with a built-in level.
• Marking and angle verification.
• Square head has a screw in Scriber pin located in the square head.

• Unplug the bench grinder from the power supply.
• Remove the side cover to gain access to the flange washers.
• Remove the flange washers by locking the axle on either side and loosening the hex nuts.
• Fit the reducing bushes if required on the wire wheel and mount on the spindle.
• Fit wire wheel on spindle and tighten properly.